How to Lock any “file and folder” without any software

Hello You are looking to protect your file or folder any how any cost, don’t worry, in this article I’m going to show you how locks any file or folder using without any software. Here I will show you how to protect your file or folder, just follow these simple steps below:At first open notepad by using “win-key + R”, that means open run and type notepad into the box and press enter or open any text editor. Then copy & paste the following code below and save it “ .bat ” file extension,example for “lock.bat”, whereas the lock is given name and .bat is the file extension. Then go to your save location and double click to run it, now you should see a command prompt where need a password to open the locker. Your password is “mypassword”, you can change your password any time when you want to change.

Step-1:Open notepad or any text editor.

Blank Notepad

Step-2:Copy this code:cls:End@ECHO OFFtitle Folder Lockerif EXIST “Control Panel.{21EC2020-3AEA-1069-A2DD-08002B30309D}” goto UNLOCKif NOT EXIST Locker goto MDLOCKER:CONFIRMecho Are you sure u want to Lock the folder(Y/N)set/p “cho=>”if %cho%==Y goto LOCKif %cho%==y goto LOCKif %cho%==n goto ENDif %cho%==N goto ENDecho Invalid choice.goto CONFIRM:LOCKren Locker “Control Panel.{21EC2020-3AEA-1069-A2DD-08002B30309D}”attrib +h +s “Control Panel.{21EC2020-3AEA-1069-A2DD-08002B30309D}”echo Folder lockedgoto End:UNLOCKecho Enter password to Unlock folderset/p “pass=>”if NOT %pass%==mypassword goto FAILattrib -h -s “Control Panel.{21EC2020-3AEA-1069-A2DD-08002B30309D}”ren “Control Panel.{21EC2020-3AEA-1069-A2DD-08002B30309D}” Lockerecho Folder Unlocked successfullygoto End:FAILecho Invalid passwordgoto end:MDLOCKERmd Lockerecho Locker created successfullygoto End

Step-3:Paste into the notepad


Step-4:Save it lock.bat extension

Lock.bat & Locker

Step-5:Now go to your save location and double click to run your “ lock.bat ” file. Then open a command prompt window, here need for a password to unlock. Now you must see a “ Locker” folder on your save location. Your default Password is “mypassword”.

Changing Password

Note : If you want to change your password, then Right click your lock.bat file extension then click edit and find “mypassword” to change your password, then replace your password to “mypassword”. Example for any name, phone no. etc.              You can create this locker any drive or folder. That’s it. Enjoy……..@@@

Leave A Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.